Bogen CM-810 Instrucciones de operaciones descargar pdf (Pagina 29)

Installation and Connection

GMS810-/GMS811-FIDOR · Operating Instructions · 8013911 V1-0 · © SICK AG 29

Subject to change without notice

3.7 CAN bus

FIDOR can be connected with a CAN bus to SICK devices (SCU, BCU, I/O modules).

If no device is connected to the CAN bus socket of the FIDOR: Connect the attached termi-

nating resistor to the CAN bus socket.

3.8 Ethernet interface

Procedure



Connect the Ethernet

Socket on the FIDOR: RJ45.

3.9 Connecting the power supply

1 Compare the supplied mains voltage with the information on the type plate.

– If the voltages do not match: Please contact SICK Customer Service.

2 Connect the power supply.

The remote control used is set at the factory depending on the order.



To exchange the remote control: Please contact SICK Customer Service.



More information  Technical Information “FIDOR”.

The risk of undesired access (“hackers”) to the FIDOR is inherent when operat-

ing the FIDOR via Ethernet.



Only operate the FIDOR with firewall protection.

CAUTION: Hazards caused by electric voltages



Only let the work described in the following be carried out by skilled electri-

cians who are familiar with potential risks and are able to avoid them.

NOTICE:

Before signal connections are established (also with plug connections):



Disconnect the FIDOR and all connected devices from the mains (switch

off).

Otherwise the internal electronics can be damaged.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 77 78

Sin comentarios

Bogen CM-810 Instrucciones de operaciones Pagina 29