Bogen PI35A Especificaciones descargar pdf (Pagina 14)

The Bogen model TAMB2 Telephone Interface Module can be used to make a remote page through the telephone

system.

Note: Jumper J3 on the MCP35A printed circuit board must be set to the TELCO position. See the Special

Adjustments section for jumper information.

PT PR G/S

PAGE

OUT

CONTACT

CLOSURES

External Booster Amp

An external booster amplifier (Bogen Model BPA60) can be connected when the application requires more than

35 watts. Using an external amplifier disconnects the internal 35W amp of the MCP35A. To install, connect a RCA

cable from the MCP35A LINE OUT jack to the Hi-Z input jack on the rear panel of the BPA60 amplifier. Connect

another cable from the 25V output terminals of the booster amplifier to a 1/4” stereo phono plug wired as shown

in the figure below. Insert this into the jack labeled 25V BAL INPUT on the MCP35A.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Sin comentarios

Bogen PI35A Especificaciones Pagina 14