Bogen C35 Especificaciones

Classic Series AmplifiersC35, C60, & C100 Models© 2009 Bogen Communications, Inc.All rights reserved.Specifications subject to change without noti

Power Output (RMS)C35: 35WC60: 60WC100: 100WFrequency Response& DistortionTransformer†: 70 Hz to 16 kHz (± 2 dB) @ 1% max.4-Ohm Direct Output: 20

Troubleshooting9PROBLEM CONDITION CAUSENO SOUNDPower Switch Indicator is OFF.• Amplifier not plugged in.• AC outlet dead.• Power switch off.• Circuit

AccessoriesRPK50 - Rack Mounting Kit• Adapts Classic Series amps (Models C35, C60, and C100) for 19" rackmounting, 2 rack spaces (3-1/2")• H

CAUTIONRISK OF ELECTRIC SHOCKDO NOT OPENNotice: Every effort was made to ensure that the information in this guide was complete andaccurate at the tim

ContentsPagePANEL DESCRIPTIONS ...2-3Classic Series Front

Panel DescriptionsClassic Series Front Panel1. MIC1 Level ControlIndividual level control for a dedicated microphone input.2. MIC2/AUX1 Mode SwitchSwi

Panel DescriptionsClassic Series Rear Panel1. Amplifier OutputScrew terminal strip containing all available speaker outputs.2. Tape/BoosterRCA unbalan

InstallationPackage Contents• Classic Series Amplifier• Instruction ManualVentilationWhen using a shelf or table mount, the amplifier should stand alo

ConnectionsInput ConnectionsMicrophone ConnectionsThese inputs are for two low-impedance balanced dynamic micro-phones. Connect cable shield to center

OperationFront Panel ControlsPowerThe front panel ON/OFF switch applies power to the amplifier and isilluminated when power is ON.Input Volume Control

7OperationRear Panel ControlsTEL Volume ControlThe TEL VOLUME control on the rear panel adjusts the TEL input’spaging level. It does not affect the mi